Always a pain in the backside, isn’t it, when you’re stuck with a router that has no image on it. Format: Drive communication & 1st Sector Write OK... ................................................................................ You’ve listed some IP addresses and Im not sure which is which.Even if you up the baud rate to 115,200 it still takes an age to download an image over the serial port to the thing. Copying file c1841-advipservicesk9-mz.124-13to flash. program load complete, entry point: 0x8000f000, size: 0xc100 . My Router doesnt have any flash files so I dont have a clue what it’s IP might be.First, copy all the necessary files to the flash on the switch, either to the disk0: or sup-bootflash: or bootflash: depending on what space is available in flash: and verify the md5 checksum of the IOS images.
Telugu sex videos yes - Updating ios on 6506 sup720
There are three regions (including the Gold region) where versions of the ROMMON image can be stored.
The ROMMON software upgrade feature allows you to have two upgraded ROMMON images (one in region F1, the second in region F2) in addition to the Gold ROMMON stored on the one-time programmable (OTP) EPROM section of the ROMMON.
The Supervisor Engine 720 (or the Supervisor Engine 720-10GE) ROMMONs consists of two modules:- A resident module that is not changed during the upgrade procedure. - An upgradeable module that is updated during the upgrade procedure.
This is the only module that you have to download from cisco.
You can check the running version using one of the following methods: Check the logs while booting: 12.2(33)SXH2 Ok Mod Sub-Module Model Serial Hw Status---- --------------------------- ------------------ ----------- ------- ------- 6 Policy Feature Card 3 WS-F6K-PFC3BXL XXXXXXXXXXX 1.8 Ok 6 MSFC3 Daughterboard WS-SUP720 XXXXXXXXXXX 3.0 Ok Mod Online Diag Status---- ------------------- 6 Pass This is the MSFC3 Route Processor ROMMON.
You'll find the release notes here (latest version is 12.2(17r)SX5).
It provides 80 gigabits per slot on all slots of 6500-E chassis.
The 6500 currently supports three operating systems: Cat OS, Native IOS and Modular IOS.
More recent routers seem to have a TFTP client built-into the ROMMON software though. Not sure if resetting it will set the IP to the default of .1. Mark, The router’s IP address is determined by the IP_ADDRESS statement in the original post.
Not entirely sure how recent a router has to be in order to have this facility, but it’s very handy and saves a lot of time. The IP address you give it is completely arbitrary.
Third, enter the “show module” look for CEF720 modules.